MIDI 1U (rev002)

Note: Check the back of your module under the MAIN label for the module revision number.

Entering Bootloader

1. Turn off power to your modular system.
2. Disconnect all cables, including patch cables and DIN MIDI cables from the MIDI 1U.
3. The MIDI 1U should already connected to the USB port on your case. Connect a USB cable from your case's USB port to your computer. (Note: There is no USB port on the rear of the module.)
4. Hold down the LEARN button on the module and turn on power to your modular system.

Changelog

1.2.10.0 (2026-06-01) Rev002/3 ONLY

• Minor bug fixes and tweaks.

1.2.9.0 (2025-02-24)

• TWEAK: USB Product ID Updated.

1.2.7.0 / 1.2.8.0 (2024-10-01)

• Extended the range of Pitch Bench to 48 Semitones.
• Config App (1.6.2.0 or higher required) available at intellijel.com/support.

1.2.6.0 (2023-10-05)

• Extended the assignable CCs available to the full range, 0-127.
• Config App (1.4.3.0 or higher required) available at intellijel.com/support.

1.2.4.0 (2022-11-03)

• The increased rates from 1.2.2 were causing instability with the onboard DAC (module appeared to hang on boot, intermittently). We've reduced the rate, but it's still double that of pre-1.2.2 versions.
• Fixes Serial MIDI issues with Rev002 units (no issues with Rev001).

1.2.2.0 (2022-09-15)

• Increase communication rates with CVx. Only noticeable when using 2 or more CVx modules.

1.2.0.0 (2021-12-03)

Note: IntellijelConfig.App v1.2 required for advanced configuration. Available at intellijel.com/support.

• New "Gate (Any)" Output Type option for paraphony on Mono Synths.
• Added Portamento support for Mono Synths.
• Added arbitrary clock divisions for Custom Outputs.
• Increased clock divider range for Custom Outputs.
• Misc bug fixes.

1.1.4.0 (2021-10-28)

• Internal/Initial release.