Planar

Entering Bootloader

1. Turn off power to your modular system.
2. Connect a USB cable from the rear of the module to your computer.
3. Hold down the ABCD button on the front panel and turn on power to your modular system.

Changelog

1.3.1 (2024-07-25)

• Fixed: Reduced SENSE jitter from slow joystick movements.

1.3 (2024-04-03)

• Tweak: Looper, Controls, and all CV I/O operate at vastly higher sample rates.
• Tweak: Adjusted filtering on X/Y for smoother response.
• New: Boot toggle (Hold "Loop" on Boot) to enable 1.2.4's ramped looping behaviour.
  • GATE and PLAY Buttons will flash once when ENABLED.
  • PLAY and REC Buttons will flash once when DISABLED.
• Fixed: Ramping behaviour.
• Note: Saved state will be reset with this update (modes and toggles).

1.2.5 (2023-08-17)

• Removes slew/interpolation when reaching the end of a loop.
• No other changes, use 1.2.4 if you enjoy the ramped looping behaviour.

1.2.4 (2021-10-17)

• Adjustments to all CV modes behaviour/scaling.

1.2.3 (2021-10-08)

• Minor adjustment to Sense detection.

1.2 (2021-10-05)

• 8x loop Time (~4min).
• Support for the Gx Expander (A/B/C/D on 1/2/3/4, N/S on 5/6 and E/W on 7/8).
• Noise reduction on inputs and outputs.
• Other bug fixes.
• Updated manual available at intellijel.com/support.

1.1 (INTERNAL)

• Internal/Beta release only.

1.02 (2019-7-27)

• Fix shortened loop times.

1.01 (2019-2-28)

• Fix mixer bleed.
• Fix looper glitch.

1.00 (2018-7-27)

• Initial release.